PNEM8-Insulation Anchor M8(M10)x95

Anchor for insulation panels with M8 junction.
Simple fast and adjustable plug; the perfect solution for fixing downpipes.

Advantages
Direct fastening into the insulation material without thermal bridge, pre – mounted threaded stud made of zinc flake coating.

Suitable materials
External thermal insulation composite system (ETICS), hard foam boards, polystyrene boards, wood fiber insulation boards (pre drilling 13mm).

Usable for almost all insulated facades (> 100mm), for high pull-out and shear loads (0,10Kn in polystyrene EPS).

Outer hexagon (SW17),installation possibility for the plug.
Threaded stud M8, high corrosion resistance. Stainless steel A2 (zinc flake coating). Easy adjustment for a perfect installation.
TX drive (TX25) and hexagon head (SW13); several alternatives for installation and adjustment (outside hex-head: for firm lightening of the downpipe clamp).
Semitransparent color, good looking, paintable.
Foamed EPDM sealing ring, white, almost invisible, UV-resistant, permanent sealing.
Material: hard polyamide for perfect drilling though the plaster. Ageing resistant.
Sharp drill point: no pre-drilling required, fast, less pressure needed.
Length 95mm for high pull-out and shear loads, usable for almost all insulated facades (100m).
50mm internal metric thread M10. Wide adjustment range of 25mm.

Mounting
In can be installed with a hexagon SW17 (recommended), hexagon SW13 or TX25 bit.
The distance from the facade is 30mm, adjustable for further 25mm.